Make sure the backup file is copied to computer folderĭefault setting does not has any admin password, it's always advisable to create own admin password to access the router. Go to your computer folder, click Paste and the file will be copied: Select the backup file, click the Copy button: You may also want to copy the backup file to your computer should the router crash and you need to restore the last good setting. Notice it will backup a file with date & time as follow:
You need JavaScript enabled to view it.Ĭredit will definitely go to whoever contribute to improve this article, many thanks in advance!īefore starting any new setting, ALWAYS backup the current good setting first. I can't tell whether it's really working fine or sufficient enough for general usage purposes, please note you use it at your own risk!Īppreciate those MikroTik guru or anyone who is familiar in this aspect can advise/comment to further improve this article and help beginner like me, kindly email : This email address is being protected from spambots. Ip nat inside source static udp 10.10.10.I'm not familiar with MikroTik and Linux command, honestly I'm totally lost by reading those wiki documentation! So basically I just follow the links & guides below, copy & paste to setup: I remember my old Cisco router’s config – I used it to forward OpenVPN incoming connections (on a non-standard 7620 port) to other (non-Cisco) router behind… Maybe I should declare in GUI (the CLI’s commands are awful) in IP -> Firewall -> Filter notes -> add new… IN interface pppoe-out/dynamic (instead WAN/ether1) ? I watched many tutorials (especially on Youtube), but no one helped me.
I am using a pppoe connection to connect to my ISP from my router and I would like to set up a L2TP-IPsec server too on the same router.
It’s an old post, so, please accept my humble apologies for bothering you. If you want to avoid pasting commands into the cli you can create these firewall rules in winbox, here are some screenshots. ip firewall filterĪdd action=accept chain=input dst-port=500,1701,4500 in-interface=ether1 protocol=udp \Ĭomment="allow L2TP VPN (500,4500,1701/udp)" The ruleset can be further condensed by combining the 3 udp rules into one. These rules must be placed above any deny rules on the “input” chain. L2TP/IPSec Firewall Rule Set /ip firewall filterĪdd action=accept chain=input in-interface=ether1 protocol=ipsec-esp \Īdd action=accept chain=input dst-port=1701 in-interface=ether1 protocol=udp \Īdd action=accept chain=input dst-port=4500 in-interface=ether1 protocol=udp \Īdd action=accept chain=input dst-port=500 in-interface=ether1 protocol=udp \ When you configure a L2TP/IPSec VPN on a MikroTik RouterOS device you need to add several IP Firewall (Filter) rules to allow clients to connect from outside the network.
0 kommentar(er)
